| Precautions for accident vehicle |
Electric vehicle includes a high voltage battery, which can lead to serious accidents such as short
circuits or electric shocks if touched incorrectly. Be sure to observe all of the following below.
|
| 1. |
Personal Protective Equipment (PPE)
(Refer to High Voltage System General Safety Information and Caution -
"Personal Protective Equipment (PPE)")
|
| 2. |
Boric Acid Power or Solution
|
| 3. |
ABC Extinguisher
|
| 4. |
Towel for cleaning electrolyte
|
| 5. |
Fire blacket
|
| 6. |
Vinyl tape (for insulating terminal)
|
| 7. |
Mega ohm tester (for checking high voltage)
|
| 1. |
Before handling an accident vehicle, the technician has to wear Personal Protective Equipment (PPE).
(Refer to High Voltage System General Safety Information and Caution -
"Personal Protective Equipment (PPE)")
|
| 2. |
Never touch the power cable from which the insulating coating has been peeled off.
|
| 3. |
Since the gas is hydrogen and alkaline vapor, immediately ventilate the room and evacuate to a safe place.
|
| 4. |
If the leaked liquid comes in contact with skin, immediately neutralize the affected area with boric acid
solution, then cleanse with tap water or salt water.
|
| 5. |
Refer to "High voltage shut-off procedure" if the high voltage needs to be shut off.
(Refer to Battery Control System (Long Range) - "High Voltage Shut-off
Procedures")
|
| 6. |
After an accident, check the high voltage battery sensor data (insulation resistance, voltage deviation
between cells, DTCs, etc.) and internal damage.
|
| 7. |
When replacing the high voltage battery with a fine deformation, only the case is exchanged after checking
the change in the high voltage battery sensor data.
|
| 8. |
Determine the type of accident and the your vehicle repaired as follows.
|
Kia EV6 (CV/CV1A) 2022-2026 Workshop Manual: Front Subframe Removal and Installation - 2WD
Special Service Tool Tool Name / Number Illustration Description Ball joint puller09568 - 2J100 Used for removal of tie rod end Lower arm ball joint remover0K545 - A9100 Used for removal of front lower arm ball joint Removal • When working on high voltage system, the work should be performed by technicians who have completed the relevant training.Kia EV6 (CV/CV1A) 2022-2026 Workshop Manual: Operating conditions
The Rear View Monitor image remains active when the following conditions are satisfied: The gear is shifted from R (Reverse) to N (Neutral) or D (Drive). The Kia EV6 speed remains below approximately 6 mph (10 km/h). Non-operating conditions The Extended Rear View Monitor turns OFF under the following conditions: The gear is shifted to P (Park).