Contents:
| Single-Use Parts |
|
Symbol |
Meaning |
|
|
Do not reuse the part. Replace with a new one. |

| High Voltage Shut-off Procedures |
|
High Voltage Component : Battery System Assembly (BSA), motor assembly, inverter assembly, high voltage
junction box, power cable, etc.
|
| 1. |
Check the Battery Management Unit (BMU) weld flag with the KDS.
(Data Analysis → Battery Management System (BMS) → BMU Weld Flag)
|
| 2. |
Open the front trunk (A).
|
| 3. |
Open the low voltage (12 V) battery service cover (A).
|
| 4. |
Turn the POWER OFF, separate the low voltage (12 V) battery ( - ) terminal (A).
|
| 5. |
Disconnect the service interlock connector (A).
|
| 6. |
Remove the front under cover.
(Refer to Motor and Reduction Gear System - "Front Under
Cover")
|
| 7. |
Remove the high voltage battery cover (A).
|
| 8. |
Disconnect the front high voltage junction box power cable (A).
|
| 9. |
Remove the center floor rear under cover.
(Refer to Motor and Reduction Gear System - "Rear Under
Cover")
|
| 10. |
Disconnect the Integrated Charge Control Unit (ICCU) connector (A).
|
| 11. |
Disconnect the rear high voltage junction box power cable (A).
|
| 12. |
Measure the voltage between the high voltage power connector and high voltage battery terminal to check
whether the high voltage is shut-off.
|
| Special Service Tool |
|
Tool Name / Number |
Illustration |
Description |
|
Front View Camera Calibration target 09890 - 3V100 |
|
Used to calibrate the front view camera |
|
SCC Setting Beam 09964 - C1200 |
|
Used to calibrate the front radar Used to calibrate the front view camera |
|
Vertical Plumb 09958 - 3T010 |
|
Used to calibrate the front radar |
|
Digital Inclinometer 09958 - 3T100 |
|
Used to measure the radar vertical angle |
|
Front Radar Setting Reflector 09964 - C1100 |
|
Used to calibrate the front radar |
|
Calibration Reflector 0K964 - J5100 |
|
Used to calibrate the front radar |
|
Front Radar Setting Tripod 09964 - C1300 |
|
Used to calibrate the front radar |
Kia EV6 (CV/CV1A) 2022-2026 Workshop Manual: Safe Exit Warning (SEW): (if equipped)
The Kia EV6 Safe Exit Warning (SEW) system is designed to help reduce the risk of accidents when passengers exit the vehicle. While the Kia EV6 is stopped, Safe Exit Warning can monitor vehicles approaching from the rear side area and provide visual and audible warnings if a passenger attempts to open a door when a potential collision risk is detected.Kia EV6 (CV/CV1A) 2022-2026 Workshop Manual: Charging and climate
Tap the corresponding icon on the Kia EV6 infotainment screen to access Scheduled Charging and Target Temperature settings. NOTE To use scheduled charging features, the Kia EV6 must remain connected to a charging cable at the scheduled charging time. You can configure charging schedules, charging dates, charging times, and target cabin climate temperatures.